TECHNICAL MANUALIL-246-C (Replaces IL-246-B)April - 2013IMPORTANT: Before using this equipment, care-fully read SAFETY PRECAUTIONS, starting on pa
> Avoid applicator to targe distances of over 12-inches, excessive applicator to tar-get distances will result in wrapback.NOTETUBULAR WORKTubular
A. Voltage by itself will not pull paint into deep recesses, but instead, paint will be attracted to more exposed edges.B. Solution: Move
1324Adjust fan pattern in accordance with size of object to be coated. Never swing spray applicator in an arc, hold applicator steady in a position at
For most economical and efcient coating, trig-ger applicator "ON" just before leading edge of object, trigger applicator "OFF" ju
SAFETY REQUIREMENTSPersonnel• Operators must NOT wear gloves that insulate them from the applicator handle.• ALL personnel in the spraying area MU
MANUAL CHANGE SUMMARYThis manual was published to supercede Technical Manual IL-246-B, Ransburg Vector Applicators Electro-Air Spray Techniques, to m
Form No. IL-246-CLitho in U.S.A.04/13© 2013 Ransburg. All rights reserved.Models and specications subject to change without notice.Manufacturing1910
NOTE: This manual has been changed from IL-246-B to revision IL-246-C. Reasons for this change are noted under “Manual Change Summary” inside t
VECTOR AND VECTOR SOLO APPLICATOR SPRAY TECHNIQUES:USE THE RIGHT TECHNIQUE...
Before operating, maintaining, or servicing any Ransburg electrostatic coating system, read and un-derstand all of the technical and safety literature
FAN CONTROLThe size of the object being coated is the determining factor in adjusting the fan pattern; the larger the object, the larger the required
HORIZONTAL PASSESThe spray applicator should be maintained in a position at right angles to the object and should be moved in a path parallel to the o
> The object being coated is maintained at ground potential, the spray applicator oper-ator is also grounded, therefore, the operator has as much
> If front and back are both sprayed, there may be enough wrap using Technique B or C to coat a small edge or ange. If wide anges are to be coat
LARGE OBJECTSBlendingIf the size of the object is greater than the spray applicator operator can reach, it should be coated in segments, the size of e
Comments to this Manuals