TECHNICAL MANUAL IL-211-DReplaces (IL-211-C)IMPORTANT: Before using this equipment, carefully read all instructions in this manual. Keep this Tech-n
IL-211-D7No. 2 Process Handgun Spray TechniquesFLAT SURFACES (Continued)On at work, patterns may be overlapped as much as 50%.Another suitabl
IL-211-D8No. 2 Process Handgun Spray TechniquesTUBULAR WORKThe gun should normally be positioned about 4 to 6 inches from the part and held almost per
IL-211-D9No. 2 Process Handgun Spray TechniquesUSE THE RIGHT TECHNIQUENo. 2 Process HandgunOverspray and drift are almost totally eliminated by the No
IL-211-DCoating the outside of the target rst puts little paint on the inside. If the inside is coated last, double coating of the edges can result.
IL-211-DSAFETY REQUIREMENTSAll conductive objects in the spray area MUST be grounded!• Keep all work holders and hooks free of coating material. The
IL-211-DMANUAL CHANGE SUMMARYThis manual was published to replace Technical Manual IL-211-C No. 2 Process Handgun Spray Techniques, to make the follow
Service Manual Price: $20.00 (U.S.)Form No. IL-211-DLitho in U.S.A.03/13© 2013 Ransburg. All rights reserved.Models and specications subject to chan
IL-211-DNOTE: This manual has been changed from revision IL-211-C to revision IL-211-D. Reasons for this change are noted under “Manual Change Summa
IL-211-DNO. 2 PROCESS HANDGUN SPRAY TECHNIQUES:ANGLES AND RECESSES...
IL-211-D1DO NOT GAMBLE! Reggie Ransburg says: “Before you get into the game, nd out what the rules are.”Before operating, maintaining, or servicing
IL-211-D2No. 2 Process Handgun Spray TechniquesANGLES AND RECESSESGeneral Rule: "Coat the most difcult areas rst."While you work on the mo
IL-211-D3No. 2 Process Handgun Spray TechniquesSPRAY PATTERNSThe spray pattern varies in size from 10 inches minimum to 18 inches maximum (approximate
IL-211-D4No. 2 Process Handgun Spray TechniquesFair pattern with poor atomization - Excessive paint delivery or poor paint mixture.A good spray
IL-211-D5Tune-Up Your System the RansCrafted WayFLAT SURFACESPoor TechniqueWhen the gun is moved in an arc, heavier lms will result in the center of
IL-211-D6Tune-Up Your System the RansCrafted WayThe normal gun to target distance should be ap-proximately 4 to 6 inches. This allows a good
Comments to this Manuals